servo amplifier

英 [ˈsɜːvəʊ ˈæmplɪfaɪə(r)] 美 [ˈsɜːrvoʊ ˈæmplɪfaɪər]

网络  伺服放大器; 伺服驱动器; 跟踪系统放大器

计算机



双语例句

  1. Self-balancing magnetic servo amplifier
    自平衡磁伺服放大器
  2. Servo motors, servo ECO-drives, touchscreen monitors, amplifier cards, modules, prom processors, valves, hydraulic pumps, line filters, rotars, and stators can be found here.
    主要是以下产品:伺服电机、ECO伺服驱动器、触摸屏、放大器板卡和电源模块等。
  3. Elevation servo power amplifier
    俯仰伺服功率放大器
  4. The Design of Servo-amplifier and the Realization of Simulation
    伺服放大器的设计及特性仿真
  5. But the set up time reduction slowed observably, as the power supply voltage was increased to about 3 times as large as the servo amplifier output voltage corresponding to rated current.
    随着电源电压的增大,控制电流建立时间减小,当电源电压达到伺服放大器额定控制电流所对应的输出电压的3~4倍以上时,电源电压对提高伺服放大器动态性能的作用明显减弱。
  6. As the power supply voltage on servo amplifier was increased, the set up time for controlled current was reduced.
    利用两种模型研究阶跃信号输入时,电源电压变化对伺服放大器控制电流建立时间的影响。
  7. Based on the hydraulic theory, design a set of electric hydraulic servo system, including the design of servo valve, servo amplifier, position sensor, DAQ.
    根据得出的理论基础,设计一套电液伺服系统,包括电液伺服阀的设计、伺服放大器的设计、传感器的设计,数据采集卡的设计。
  8. Research and Development of AD μ C81 2 Based Detector of Servo Amplifier
    基于ADμC812的伺服放大器检测仪的研制
  9. The electro-hydraulic servo unit which the system used, is the digital electro-hydraulic servo unit, the servo amplifier is embedded in the electro-hydraulic servo valve;
    系统的电液伺服装置为数字式电液伺服装置,其中,伺服放大器嵌入在电液伺服阀中;
  10. Design of a PWM type electro-hydraulic servo amplifier
    一种PWM式电液伺服放大器的设计
  11. A spaceborne angular velocity servo system for electro-optical tracking of space targets is designed, which consists of a compensator, a driver and a power amplifier, a mechanical assembly to control optical telescope and tracking gimbal and the LOS stabilization loop.
    设计了星载空间目标光电跟踪角速度伺服系统,它包括补偿校正环节、驱动功放环节、以光学望远镜和跟踪架为被控制对象的机械操作环节以及视轴稳定回路。
  12. The design principle and specific process of the pulse width servo amplifier is introduced, which is used to drive direct current motor to work.
    介绍一种脉冲调宽型伺服放大器的设计原理及具体过程。
  13. Design of the pulse width servo amplifier
    一种脉冲调宽型伺服放大器的设计
  14. This dissertation introduces the background and significance of the research and the present situation and developing prospect of the EMA Servo amplifier.
    论文介绍了选题背景和意义以及电动舵机伺服放大器的现状和发展前景。
  15. Hydraulic AGC system is been made of main dynamic element, which include signal conditioner 、 servo amplifier 、 hydraulic servo valve 、 fluid cylinder 、 mill roll and primary detector, etc. These elements have high nonlinear feature, the system have inevitably high nonlinear.
    液压AGC系统主要由信号调节器、伺服放大器、电液伺服阀、液压缸、轧机辊系和传感器等组成,其中的液压器件具有高度非线性特点,其系统必然也具有高度的非线性。
  16. This paper introduces the composition of electro-hydraulic servo control system. Especially, the triangular wave generator, PWM principle and the power amplifier stage circuit in the servo amplifier are described. Finally, the frequency response of servo valve to the PWM driving signal is analysed.
    在此介绍了电液伺服控制系统的组成,对伺服放大器中的三角波发生器、PWM调制原理和功率放大级电路进行了详细说明,并分析了伺服阀对PWM信号的频率响应特性。
  17. If the efficiency of servo amplifier is considered, it is practicable that the power supply voltage is about 3 times as large as the servo amplifier output voltage corresponding to rated current.
    若考虑伺服放大器效率及电源功率等因素,伺服放大器电源电压应取额定输出电流所对应的伺服放大器输出电压的3倍左右为宜。
  18. The experiment results show that phase phenomena are probably caused while the servo amplifier gain and the amplitude of input signal increase to some extent.
    实验结果表明,当伺服放大器增益和输入信号的幅值较大时都有可能促成系统的相位突变。
  19. This paper introduces a control system of loading manipulator in the filling and boxing line of a vinegar-producing factory. The system is composed of S7-300 PLC, touch panel, servo amplifier, servo motor and manipulator.
    介绍了某醋厂灌装生产线装箱机械手控制系统,该系统由S7-300PLC控制器、触摸屏、伺服放大器、同步伺服电机、机械手等组成。
  20. Design and calculation of the multidirectional wave generator servo amplifier are de-scribed. And the key problems of simultaneous adjustment of many wave-pushing boards are analyzed.
    阐述蛇形造波机伺服放大器的设计与计算,并分析了多台同步调试的关键问题。
  21. Effect of the Power Supply Voltage on the Dynamic Performance of Servo Amplifier
    电源电压对伺服放大器动态特性的影响
  22. The part of the hardware emphasizes on the design of the servo amplifier and the testing of the circuit, then deducing the model of the servo system.
    硬件部分致力于伺服元器件的选择、放大板的设计及电路调试,并测试系统的数学模型;
  23. Firstly, according to purpose of designing and making mechatronics coupling experiment bench, demonstrate project of experiment bench, establish mathematics model of experiment bench, which consist of mechanism transmission systems servo amplifier and servo motor.
    首先,从研制机电参数耦合实验台的目的出发,论证实验台的设计方案,建立实验台的数学模型,包括机械传动系统、伺服放大器和伺服电机。
  24. The part of the hardware emphasizes on the design of the servo amplifier, and presents the model of the servo system.
    硬件部分致力于伺服放大器的设计,并构建实际系统。
  25. Simulation results show that servo amplifier gain is the main factor affecting system performance in the control system.
    仿真结果表明,在角度控制系统中,伺服放大器增益是影响系统性能的最主要因素。
  26. In high precision DC servo system, the PWM power amplifier based on power electronic devices is mainly used.
    在高精度伺服控制系统中,大多采用基于电力电子器件的脉宽调制型功率放大器,简称PWM功率放大器。
  27. In order to improve the steady performance of control system, the result of simulation is corrected by PID. The performance defect of system be compensated and the appropriate servo amplifier is selected.
    为了提高控制系统的性能,使系统的稳态性能得到进一步改善,由仿真结果对控制系统进行PID校正,来补偿原系统的性能缺陷,进而选取合适的伺服放大器。